Preparation before configuration:

  1) Power on the camera, press and hold the reset button for several seconds, and then hear the camera prompt "Reset completed". When the camera prompts "Please scan the QR code on the camera and wait for connection" and the (starting with XVV) hotspot signal is found in the WiFi list of the mobile phone, it means that the device is waiting for configuration

  2) The mobile phone opens WLAN and connects the WiFi used to configure the camera network

Configuration steps:

  1) Click the "+" button in the upper right corner of the device list. If the QR code is damaged, click [Can't find the QR code on the device], and select [QR code connection]

  2) Select the WiFi that the device needs to configure, enter the WiFi password, and click [Confirm]

  3) Point the QR code generated by the mobile phone at the camera lens, and continue to operate according to the system prompts

  4) Camera prompts "Received configuration information - Connecting - Network connected" indicates successful configuration, and APP prompts "Added successfully"

Indicator light status:

  1) Indicator is off: device is powered off or standby mode

  2) Slow flashing red light: device is ready for connecting

  3) Quick flashing red light: device is connecting to the router

  4) Solid yellow light: device has been connected to the Internet

  5) Flashing yellow light: device is connecting to the Internet. If the device cannot connect to the Internet normally, please check whether the router can access the Internet normally