Preparation before configuration:

  1) Power on the camera, press and hold the reset button for a few seconds, and then hear the camera voice prompts " Restore factory default settings - access point preparing - access point ready". When the (MV+ID/HSC+ID) hotspot signal is found in the WiFi list of the mobile phone, it means that the device is in the waiting configuration state

  Note: The voice prompts may be different, please refer to the actual prompts of the camera

Configuration steps:

  1) Click the "+" button in the upper right corner of the device list, select [Add Camera]

  2) Scan the QR code on the device or swipe up the bottom and select [Wi-Fi Camera]-[AP hotspot connection], and follow the system prompts to continue operation

  3) Select the WiFi that the device needs to configure, enter the WiFi password, and click [Confirm]

  4) Below Android 10: Select the device hotspot, and the mobile phone will automatically start network configuration after connecting to the hotspot

      Android 10 and above: Click [Connect AP spot] or enter the mobile phone system [Settings], select [WLAN], connect to the device hotspot (MV+ID/HSC+ID), and the device will automatically connect to WiFi after returning to the app

  5) The camera's voice prompts "WiFi connecting - WiFi connected" to indicate that the configuration is successful, and the APP prompts "Completed"